- System and Slot Data Measurements The DSC - SP2000 Platforms provide data measurements on a per system and per slot (CPU) or virtual slot (VM) basis as described in the following figure and table provides an example for a file that includes such measurements. Note the separate lines containing data for system and for slot data measurements.
- The first slot dimensioning method (a) provides the width and the distance between the end radii center points.
The width of a female dovetail slot is measured along the long axis of the barrel at the bottom of the slot, the widest fore and aft point of the dovetail. If the slot is tapered, the right opening, with the. This PolyWorks training video will explain how to capture slot data in a measurement session. This is useful for ensuring accuracy and helping to demonstrate.
THERE ARE NO INDUSTRY STANDARDS OR SIZES IN MAIL SLOTS. YOU MUST MEASURE ACCURATELY!
Successful purchases and installations depend entirely on accurate measurements.
One manufacturer's 'magazine' size may be another manufacturer's 'letter' size. Even our 'Elite' magazine size is a different size from our 'Classic Surface Mount' magazine size.
There is a high likelihood of dissatisfaction with inaccurate measurements.
Remove your existing mail slot and measure the width and height of the actual hole cut through your door or wall.
Only the size of the hole cut through your door or wall determines if one of our mail slots will fit.
NB. Although it is always easier to increase the size of an existing hole than decrease it …
Click here to read ways of decreasing the size of a pre-existing hole or watch the tutorials.
How To Measure
Step 1. Remove interior AND exterior face plates of existing mail slot from your door or wall
Step 2. Measure the width and height of the 'actual hole cut through your door or wall' from both the interior AND the exterior sides of your door or wall and write measurements down
Parking Slot Measurement
Step 3. Repeat measuring process to make sure your measurements are accurate as in the adage 'Measure twice, cut once'
Step 4. You now have your 'Cut Out Size' measurements
Step 5. Proceed to our 'Products' page to select the appropriate mail slot for your needs
Step 6. Compare your 'Cut Out Size' measurements to the 'Cut Out Size' measurements of one of our products
Step 7. For optimal installation your measurements must be smaller than our product's 'Overall Frame Size'
Pc Dmis Slot Measurement
NB. If one or both of your height or width measurements of the 'actual hole cut through your door or wall' are larger than the measurements of our 'Overall Frame Size', click here for information on advanced installations.
Slot Antenna Measurement
Click here to watch the tutorials
